 info@unionwells.com |  +86-18169936698

MICRO SWITCH NEWS CENTER

Home » News » Switch Knowledge » 7 steps to Replace your Fridge Micro switch

7 steps to Replace your Fridge Micro switch

Views:5     Author:China Micro Switch Manufacturer     Publish Time: 2020-07-31      Origin:https://www.unionwells.com/

If you know how to perform basic repairs, you can make your appliances last much longer, which can save you a lot of money. In this article, we are going to help you replace your fridge micro switch. In the beginning, it may not be easy for you to replace the unit. However, if you follow the steps given below, you will find it much easier to perform the replacement. 

micro switch manufacturer35

1: Get the Tools you Need 

Duct tape 

Putty knife 

Flat blade screwdriver 

Micro switch


2: Disconnect the Power 

Before you work on any type of electrical appliance, make sure you disconnect the power supply first. It is important for your safety and the safety of everyone around you. So, make sure you have disconnected the power supply. 


3: Take off the Drip Tray 

Your next step is to remove the drip tray. This part is located at the bottom of the unit. You can use duct tape in order to protect the finish. Next, you should put the putty knife below the escutcheon and then pull it down and out in order to separate it. 

You will see that it is connected to different spots. Therefore, you should start at the bottom and pull it out by tilting it first. 

After the drip tray has been removed, you will find the 5-pin plug. This is a component that is a power source for the switches. All you need to do is disconnect the plug and put it aside before following the next step. 


4: Remove the Old Micro-Switch 

Now you can access the micro switch. They will be fixed with the help of plastic tabs and hooks. First of all, you should pull the hook and set it aside. Once you have removed the switch, you can easily pull it. You can use a flat blade screwdriver to remove the wire connector. This is the old micro switch that you need to replace.


5: Install the New Switch 

Now you need to follow all of the previous steps in reverse. You can get the new switch and connect it to the wire connector. It should be properly fixed. Now, you can rotate it into the position while lining up the diagonal holes with the plastic posts. Next, you may want to push it

over in order to fix the locking caps. Lastly, you should everything to ensure all of the wires are out of the way.


6: Reconnect the Switches 

Once you have replaced the micro switch, you can reconnect the connector. Make sure that the locking tab is in place. Next, you should elevate it in order to ensure it is over the dispenser housing. You can then tap it to ensure it is locked in place.


7: Finish Up 

Once you have installed the new switch and reconnected the power, your final step is to replace the drip tray. 

So, these are just a few simple steps that you can follow in order to replace your fridge micro switch. 

micro switch manufacturer15

RB:

Are you interested in buying micro switches from a China micro switches manufacturer?For more about micro swithes,please contact unionwell at https://www.unionwells.com


QUICK LINKS

Switch Products

CONTACT INFO

  (+86)-0752-6236969
   (+86)-752-5976966
    (+86)-18169936698
  info@unionwells.com
 Huizhou City,Guangdong Province, China

UNIONWELL SWITCH

We are a switch manufacturing enterprise with more than 25 years’ experience in making switches. All of our switches have UL, ENEC, EK, CQC etc. approvals. Our switches are widely used in electronic instruments, home appliances, automotive electronics and electric tools, annual production capacity more than 300 million pcs of switches.
Copyrights 2020 Unionwell Switch. All rights reserved.